Euromag MUT1000EL, Инструкция по эксплуатации, Страница: 32 / 54

32 / 54 32 / 54
Sensors
EUROMAG | SENSORS | Ed. 04/2019
5
ELECTRICAL CONNECTION
5.1 SEPARATE VERSION SENSOR CONNECTION
All operations on the electrical connections must be carried out if the instrument is disconnected
from the mains and/or from the battery!
All operations performed on the electrical junction box or the electrical components of the device
must be carried out by duly trained and specialized personnel.
The sensor is supplied with cables connected and resin coated in the separation box unless otherwise
requested by the customer.
The following diagrams, for the connection of the separation cables between sensor and converter,
may vary according to the type of converter; therefore, follow the indications given in the relevant
documentation.
A
B
T
C
D
E
F
A
B
T
C
D
E
F
F
E
D
C
T
F
B
A
JUNCTION BOX OF THE
SENSOR
JUNCTION BOX OF THE
CONVERTER
ONLY DOUBLE-
SHIELDED CABLES
C028
Fig. 51
Info: If cables in the coil are used, always use the ferrules for the connections in the terminal
board and adequately insulate the shields.
Info: use only cables supplied by Euromag International.
ATTENTION: After making all the necessary connections, make sure to properly tighten the cable
glands and the cover, in order to protect the insulation of the cables and the electrical/electronic
boards from humidity and water in case the converter is installed outdoors. Refer to the manual
of the relative converter for more information.