Euromacchine LAMPO GREEN, Инструкция по установке, использованию и техническому обслуживанию

Страница: 16 / 84

LAMPO Multifunction Unit
2 TRANSPORT, STORAGE AND INSTALLATION
2.1 QUALIFIED OPERATORS INVOLVED IN SECTION
2.2 REQUIRED PPE - RESIDUAL RISKS
2.3 HANDLING THE PACKED MACHINE
Case unloading, transport and handling
Upon arrival, the parts of the machine must be unloaded and handled with the maximum care, carefully following the instructions given on the walls of the
cases or those contained in this manual.
It is very important to check that the capacity of the single lifting equipment corresponds at least to the loads to be lifted, increased by the safety
margins required by the current regulations.
After having unpacked all the components of the machine, verify their status, checking that there are no damaged parts due to the transport.
Otherwise:
•
Immediately notify the carrier;
•
Inform the MANUFACTURER with registered letter with acknowledgement of receipt or by certified e-mail, sent to the address indicated in the introductory
section of this manual.
The communication of any damage and/or anomaly must be timely and in any case must be received within 15 days from the date of delivery.
Package disposal
After stacking them separately (wood, cardboard, PP, PE, etc.), it is necessary to dispose of these materials according to the regulations in force and, where
possible, to recycle them.
2.4 ASSEMBLY
FORKLIFT
FORKLIFT
FORKLIFT
2
3
5
6
7
9
8
10
1 - Lift the Lampo with suitable forklift
2 - Install the helm.
3 - Install the rear stabilisers
4 - Place the machine on the ground
5 - Install the axle
6 - Install the wheels and mudguards, if any
7 - Hook the flag with suitable ropes or chains
8 - Position the flag paying attention to the rear
seat and to the lower pins
9 - Fasten the flag to the machine
10 - Check the correct installation of the flag
and release it from ropes or chains
14