19
Installation, Location and Connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
Screw the 2 x 2 swivel castors (3) with the 4 capped nuts (2) onto the ends of the
two wheel supports (1). The wheels should be at the hollow side!
Turn the radiator upside-
down (make sure you don’t scratch the paint or the
floor!)
Attach the two supports (each with 2 swivel castors) to the radiator. Slide the U-
shaped bolts onto both sides between the outer fins of the radiator, the end the
screw thread and the outwards facing curve.
First slide the supports (with the swivel castors) over the curve and then over the
end of the screw thread.
Please note: the wheels should be placed as far away from one another as
possible!
Return the heater to its upright position, wheels down.
Warning: only use the heater when it is in an upright position, with the wheels
attached to the bottom (as pictured on the front of this booklet). Any other
position is dangerous!
Choose a suitable location for the heater which is at least one metre away from
any obstructions, walls or inflammable materials (see also safety instructions).
Make sure a functioning heater is always placed on a solid, flat and horizontal
surface. Never place it on a bed, couch, deep pile carpet etcetera!
Check that the socket used is earthed and that it matches the power specified on
the heater’s type plate.
