EUROM OK115T, Инструкция пользователя

Страница: 32 / 52

32
less maintenance is required. Paraffin is also more resistant to extremely low
temperatures.

NEVER use other fuels such as petrol, alcohol, oil compounds or similar in this
heater; this could lead to fire or explosion!

NEVER store paraffin in direct sunlight of near a source of heat.

Do not store paraffin in living/work areas but in a well-ventilated area such as a
shed, storage area or similar.

NEVER use paraffin from the previous season. Paraffin deteriorates in quality and
will not burn properly as a result.
Electrical connection
Before use, check the device and the electrical cable, plug and socket for any
damage or wear and tear and do not use if you discover any problems.
This heater is fitted with a standard 230V - 13A plug. Choose an impact-resistant
type if it ever needs replacing. The electricity network to which the heater is
connected must be equipped with an earth leakage circuit breaker (30 mA) and the
socket must be earthed.
Repairs to the electrical system must always be carried out by a qualified electrician!

Before use, always check that the socket is of the correct voltage, is earthed, has
an adequate fuse (5A) and forms part of a mains network with an earth leakage
circuit breaker.

If you have to use an extension cable, make sure that the cable is of a suitable
width which is appropriate for the voltage and amperage.
Instructions for use
Starting the heater:

Place the heater on a stable, flat and horizontal surface.

Remove the tank cap.

Fill the tank with paraffin or diesel
until the fuel meter needle is on “F”.

Replace the cap on the tank.
Note: Never replenish fuel if the heater is on or is still hot. Always wait until the
heater has cooled down before topping up the fuel.
Never fill up the fuel in an enclosed area; always do it outdoors.
Do not overfill the heater and remove any spilt fuel immediately, before using the
heater.

Now insert the plug into the socket.

Turn the thermostat button as far as possible in a clockwise direction

Press the ON/OFF switch to ON. The display shows the set temperature for 2
seconds, then shows the current temperature.