EUROM 363234, Инструкция по эксплуатации

Страница: 39 / 116

39
not hang the device directly under or in front of an electrical socket (see
diagram 1).
 The wall supports must be attached horizontally (use a spirit level!) to the wall.
Determine the location of the wall supports (take the above into account), mark
the location of the screws and drill 5 holes at the marked places using a 6 mm
drill. Put the plugs into the holes and then screw the wall supports to the wall.
Be aware of pipes that may be contained within the walls when drilling holes!
 Attach the securing-bracket with both self-tapping screws underneath the
fireplace in the holes provided. The flat side of the bracket must be placed
against the underside of the fireplace; the other must rest against the wall so
that the wall piece sticks out under the fireplace (diagram 3). This bracket will
be hidden from sight once the glass screen has been installed.
 Now hang the fireplace carefully on the central wall support with the hanging
bracket (see diagram 2). The bracket should not stick out from the support! The
electrical cable comes out at the right hand, lower side of the fireplace and must
be placed out of range of the heat.
 Now mark the location at which the securing-bracket must be screwed to the
wall. Remove the fireplace from the wall, drill both holes and insert a plug. Hang
the fireplace on the bracket and screw the securing bracket to the wall.
 Hang the glass plate (two people are needed for this job!) with the four hooks
over the four knobs on the sides of the fireplace and check that all four hooks
are correctly attached (see diagram 4). Secure the glass plate by tightening the
screw that goes through the bracket (which sits on the glass plate).
 Installation is now complete.