EUROM 335347, Инструкция по эксплуатации

Страница: 24 / 56

24
and qualified for the foundation. The material provided is identified for a brick
wall; for another foundation please ask the specialist for suitable material.
 Check before mounting or the minimum safe mounting distances between heater
and environment are strictly followed. The distance between the bottom edge of
the appliance and the floor must be at least 1,8 meter. There must be a distance
of at least 0,3 meter between the appliance and the ceiling, roof or other cover.
If the covers consist of flammable material (for example canvas etc.), the
distance has to be at least 1 meter and if you focus the radiator upwards, at least
2 meter. There must be a distance of at least 0,5 meter at each side between the
appliance and walls or the like. When you
install the appliance outside, pay attention
that it doesn’t catch excessive wind load.
 Fix the mounting bracket totally horizontal
on the wall with the three anchor dowels
provided. The short side of the bracket has
to point upwards (see fig.).
 Assemble the appliance onto the mounting
bracket with the two winged nuts, the
cable at the underside of the appliance
(see fig.).
 Adjust the desired angle of radiation. The
radiator can turn 115°: from half upside
till almost totally downwards. Pay
attention that the radiator doesn’t focus its
heat from a short distance at combustible
materials! The recommended number of
degrees to the mounting wall is 45° (see
fig.)
 Fasten all screws another time firmly and
check or the heater is firmly mounted.
Now your infrared heater is ready for use.
 For personal protection the installation, to
which the Eurom Comfy is connected, has
to be equipped with an earth fall device
(max. 30 mA).
Under some circumstances it may be attractive to make a fast connection between
the heater and the main supply, and to operate the heater with a switch. Because
the Eurom Comfy has a high water tightness (IP65) and for safety reasons, such a
connection has to be made by a qualified electrician.
Working
Check for every use:
- or the appliance doesn’t show signs of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating
duet or wind or rain could lead to loose.