EUROM 262926, Руководство по эксплуатации, Страница: 7 / 36

7
Technical specifications
Type TP800P TP800R TP1200R
Power 800W 800W 1200W
Capacity max. 53 l/m 53 l/m 63 l/m
Discharge head
max. 40m 40m 48m
Suction height max. 8m 8m 8m
Connections 1” – 1” 1” – 1” 1” – 1”
Supply voltage 230V-50Hz 230V-50Hz 230V-50Hz
Pump housing plastic Stainless Steel Stainless Steel
Weight 6,7kg 7,8kg 8,5kg
Installation
The electric pump should be placed as close to the water surface as possible to
achieve a minimum suction height and thus reduce the loss of discharge head.
When installing the pump permanently, secure it to the surface using the holes in the
pump support.
The pump must be installed in a dry location so that it will not be submerged under
any circumstances.
Failure to comply with the above conditions may result in damage to the pump and
the entire system!
Hose connections
The suction hose must be resistant to negative pressure. The end should be kept at
least 30 cm under water to prevent the formation of vortices with the inevitable air
intake.
Connections and connectors must be absolutely watertight. Keep the number of
bends and kinks in the hoses as minimal as possible! Make sure that the tilt of the
suction hose is at least 2%.
The drain hose must have a diameter equal to or greater than the pump outlet.
Electrical connections
The electrical installation must be installed in compliance with the applicable regula-
tions and equipped with a 30 mA earth leakage circuit breaker.
The socket used must deliver 230V - 50Hz.
The power cable must comply with EEC standards and be of type H07 RN-F in compli-
ance with VDE0620.
The motor has a built-in thermal protection.
Failure to comply with the above conditions may result in damage to the pump and
the entire system and create a risk of electric shock. The manufacturer and importer
do not accept any liability for this!