•
Fitting:
Plastic.
•
Class:
Class 2
•
IP Rating:
IP 20
•
Voltage:
220V - 240V ~ 50Hz / DC 6V input
•
Dimensions:
(Ø)120mm x (H)175mm
•
Lamp Type:
36 x Integrated LED 220 - 240V
•
Battery:
4V 2000mAh sealed Lithium-ion rechargeable battery
•
Battery Charge time:
approximately 24 Hours
•
Battery Life:
3 - 4 Hours (Bright setting) | 6 - 8 Hours (Dim setting)
• The light source of this luminaire is not replaceable. When the light source reaches its end of life the
whole luminaire should be replaced, or the light source should only be replaced by the manufacturer.
SPECIFICATIONS
CLEANING
MAINTENANCE
HOW TO OPERATE
• Before cleaning always ensure the power supply is turned off.
• Do not immerse the luminaire in water.
• No abrasive products, solvents, detergent may be used to clean this luminaire.
• Ensure that the luminaire does not come in contact with corrosive chemicals, etc.
• Please Charge the unit for 8 hours before initial use.
• Make sure the voltage is correct before plugging in.
• Please keep always recharge the lantern when the light goes dim.
• Periodically charge the unit at least 8 hours when the unit is not inuse for over 3 months, ortherwise the
battery will be over-exhauseted and can not be recharge again.
• Please place the switch in OFF position when the lantern is not in use
• The efficiency may decrease if lantern is used or charged when
temperaturares are below 0
˚
or above 40
˚
.
• Do not immerse the fixture into water or keep in humidity environment
• Never use strong or volatile chemicals to clean the lantern
• To avoid damage of lantern, please do not use other specified battery.
• To avoid electrical shock, please do not open the unit unless qualified person.
1. Turn on the switch to light up the unit.
2. Plug into an AC power socket to charge or use the solar panel to charge by putting the Lantern in
direct sunlight.
3. The red LED indicator will light up when the lanrtern is being recharged.
4. It needs approximately 20 hours for a full charge.
5. The built-in charger may become slightly warm during recharging.
6. Switch Lantern OFF when not in use.
FS214 - attachments:
If the external flexible cable or cord of this luminaire is damaged, it should be exclusively replaced by
the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
To ensure that you get maximum longevity and maximum use out of your luminaire, please
observe the following safety instructions.
Electrical products can cause death, injury, or damage to property. Installation of the luminaire must
be carried out by a qualified electrician, in accordance with SANS 10142. On completion of
installation, ensure that the Certificate of Compliance is updated.
• Before connecting this luminaire, ensure that voltage indicated on the rating label corresponds with the
mains voltage in your home.
• When changing the lamp, ensure that the power is turned off.
• This luminaire is checked in full for conformity to the quality standards and safety requirements.
• The manufacturer / supplier is not responsible for any damage of properties and persons, caused by
the incorrect use or installation of the luminaire.
• Should you be unsure of how to install this luminaire correctly, please consult a professional electrician
or your supplier for assistance.
• Ensure all items/ components, threads and screws are tightly secured.
IMPORTANT:
• Tampering with this luminaire, i.e.using silicon sealers or incorrect cabling, will invalidate
your warranty.
• When the protection glass is damaged, it should be replaced immediately. The luminaire
must not be used without the protection glass.
• Please check whether the connection of the power cord is safe and reliable before installation.
• Always ensure that the mains supply voltage is correct.
• Always replace the lamp with one of an identical rating.
• Ensure that you do not place the luminaire near any combustible materials and / or surfaces.
• Choking hazard: May contain small parts. Keep away from children.
• Do not insert your fingers or any part of your body into the electrical contact and sockets of this product
whilst it is connected to the electricity supply.
• Item may vary slightly from the picture on the carton.
• Coastal humidity may effect the longevity of the luminaire.
• Outdoor luminaires must be cleaned to prevent rust occurring.
• Use a copper grease on all screws or strings.
IMPORTANT SAFEGUARDS
