3 Blade Industrial Ceiling Fan
F12B / CH / W
PRODUCT CODE
1
2
Mounting Bracket
Slotted Hole
Round Hole
Insert downrod into downrod yoke. Make sure to align
hole in downrod with the hole in downrod yoke.
Lift canopy and install yoke cross pin through yoke
downrod.
Insert clamp pin into cross pin until it snaps into place.
Tighten of set screw in yoke.
3
Clamp
Pin
Cross
Pin
Set Screws
4
Follow diagram above to connect wires.
Make sure that all exposed wiring is secured inside the
terminal block.
5
From Fan:
4 Pole
Connector
L - Block
N - Block
- Block
From House:
Power Supply
Neutral
Earth (Yellow/Green)
7
Carefully lift fan from mounting plate hook, making sure not to
break any wire connections. The canopy has 2 mating slots and 2
mating holes (see illustration). Position both slots in canopy
directly under and in line with 2 mounting plate screws and lock
washers lift fan until mounting plate screws are seated in
bottom of slots in canopy. Rotate clockwise until both
mounting screws drop into slot recesses. Tighten screws
securely. Install third and fourth screws with lock washer
into mating holes and tighten.
Mounting Slots
Mounting Slots
After fan is installed tighten
Attach blades to top of motor using screws and
washers shown above.
true-balance canopy bolts with pliers or wrench to
eliminate wobble during operation.
NOTE: Over-tightening bolts may damage canopy.
8
DOWNROD INSTALLATION ONLY
9
ATTACHING THE BLADES
WALL CONTROL INSTALLATION
WIRING GUIDE
Insert downrod and ball assembly into large opening in
canopy, making sure canopy tab engages notch in
downrod ball. Place true-balance clamp ring over down-
rod ball and install 3 true-balance bolts through the
bottom of the canopy and into clamp ring.
(These bolts will be tightened correctly in step #9) .
6
Clamp Ring
Canopy Tab
Ball Notch
1
2
3
Two Wires are required to operate the fan from the wall control.
1) “Actile” wire form lighting circuit of the fuse box, connected to
terminal A on the wall control.
2) “Fan Active” wire from the fan connects to F on the wall control.
10
L
3
2
1
A
Ø
F
NOTE: Flushmouting will not require the downrod.
shock.
components
ENVIRONMENTAL PROTECTION
Waste electrical & Electronic equipment regulations requires that any of our products showing this
marking must not be disposed of with other household or commercial waste. To prevent possible
harm to the environment or human health from uncontrolled waste disposal, please separate any
such products from other waste types and recycle it responsibly at your local facilities.
ILLUSTRATIONS
Please read instructions before commencing installation and retain for
future reference.
Cape Town - 9 Racecourse Road, Milnerton, 7441
Johannesburg - 10 Milkyway Avenue, Linbro Business Park, Sandton, 2065
email: [email protected]
, web:
www.eurolux.co.za
