Eurolux EBO605M, Инструкция по установке, эксплуатации и обслуживанию

Страница: 6 / 16

4
ELECTRICAL CONNECTION
LOCAL AUTHORITY REQUIREMENTS
Installation is only permitted by a licensed electrician and carried out according to instructions
provided by the manufacturer. Incorrect installation might cause harm and damage, for which
the manufacturer accepts no responsibility.
Electrical Installation
This oven must be connected to a 220-
240V~ 50Hz-60Hz power supply. It must be earthed via the supply cord.
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on the appliance
identification plate) must be checked for correspondence to the available mains supply voltage, and the mains electric
wiring should be suitable for the oven’s power rating (also indicated on the ap pliance identification plate). Use a suitable
electrical cable (wires minimum area1.5mm²) and a circuit breaker with a contact opening of at least 3mm must be
installed in the supply circuit.
The switched outlet must be connected to a suitable earth wiring, in conformity to current safety regulations.
The main’s switch should not be located above the appliance and no more than 1.25m away from it. The power supply
cord must not touch against any hot surfaces and must be placed so that its temperature does not exceed 75°C at any point
along its length.
After having installed the appliance, the switched outlet must always be in an accessible position.
NOTE: For connections to the mains power supply, never use adapters, reductions or multiple power points as these may
overheat and catch fire.
The mains terminal block is located on the back of the oven and the terminals are accessible by opening the terminal block
cover. Note: The back panel or terminal cover should not be opened when the mains power is still connected to the
appliance and never by an unauthorised person.
The electrical safety of this appliance can only be guaranteed if the oven is correctly and efficiently earthed. The
manufacturer declines all responsibility for damage resulting from an installation which has not been earthed correctly.
4