Eurolux DW10V-AAA-8, Инструкция по эксплуатации

Страница: 16 / 30

•
They produce good results for certain types of usage only. If you are using this type of
detergents, you need to contact the manufacturers and find out about the suitable
conditions of use.
•
When the conditions of use of such products and the machine settings are appropriate,
they ensure savings in salt and/or rinse aid consumption.
•
Contact the detergent manufacturers if you are not obtaining good wash results (if your
dishes stay calcareous and wet) after having used 2 in 1 or 3 in 1 detergents. The scope of
warranty for your machine does not cover any complaints caused by the use of these types
of detergents.
Recommended usage:
If you are using a combined detergent, then add rinse agent into your
machine ,switch the rinse agent settings into its lowest (1) position and active the tablet
detergent button in order to obtain better results.If the water hardness level is above level 4,then
it is necessary to fill in the salt container with salt.
İ
t is not recommended to use combined
detergents in fast programs.
Warning:
Should any problem, which you have not encountered before, arise with the use of
this type of detergents, contact the detergent manufacturers directly.
When you give up using combined detergents
•
Fill the salt and rinse aid compartments.
•
Adjust the water hardness setting to the highest position and run an empty-wash.
•
Adjust the water hardness level.
•
Make the suitable rinse aid setting.
Filling with rinse aid and making the setting
Rinse aid is used to prevent the stay of white water drops, lime stains, white film strip-shaped
stains that may form on the dishes, as well as to increase the drying performance. Contrary to
the popular beliefs, it is used not only for obtaining shinier dishes but also for obtaining
sufficiently dried dishes. For this reason, care should be taken that there is adequate amount of
rinse aid in the rinse aid compartment and only polishing material produced for use at
dishwashers should be used.
If the rinse aid lamp on the control panel becomes on fill the rinse
aid compartment with rinse.
To put rinse aid, remove the rinse aid compartment cap by turning
it.
1 Fill the rinse aid compartment with rinse aid until the rinse aid
level indicator becomes dark; 2 refit the cap and close it by turning
it in a way that the nails will correspond to one another. By
checking the rinse aid level indicator on the detergent dispenser,
you can understand whether or not your machine needs rinse aid.
A dark indicator
b means that there
is rinse aid in the compartment, while
a light indicator a shows that you
need to fill the compartment with
rinse aid.
The rinse aid level adjuster can be
set to a position between 1 and 6.
Factory setting for rinse aid is the
position
3 . You need to increase
the degree of the adjuster if water
stains form on your dishes after a wash, whereas you need to
decrease the degree if a blue stain is left when wiped by hand.
3
15