Front Panel Operation
5-5
5
To set the transfer mode, press
t
or
s
to select
Set
Transfer Mode
and press
ENT
Set Transfer Rate
Mode ..
for 2 seconds
Press
t
or
s
to select the Sync or Async and press
ENT
.
CHL=0
TransferMode=Sync
Change to=Async?
The controller must be reset (e.g., by powering-off then on again, by executing "Reset This
Controller" via LCD interface, etc.) for this to take effect.
6
To change the channel interface mode repeat Step 2
and 3, press
t
or
s
to select
Redefine Channel
Mode ..
Redefine Channel Mode
and press
ENT
.
Press
ENT
for two seconds to change from host to
drive channel mode or vice versa.
The controller must be reset (e.g., by powering-off then on again, by executing "Reset This
Controller" via LCD interface, etc.) for this to take effect.
7
To delete a LUN definition repeat Step 2 and 3, press
t
or
s
to select
View and
CHL=0 LUN=0
LG=0
Delete SCSI LUN
and press
ENT
.
Press
t
or
s
to select the LUN number to be deleted
and press
ENT
.
Delete this LUN
Definition ?
To confirm deletion, press
ENT
for two seconds. To
cancel, press ESC.
Channel Terminator Setting
1 Press
ENT
for two seconds for the Main Menu.
2
Press
t
or
s
to select
Set SCSI Channel Terminator
and press
ENT
.
Set SCSI Channel
Terminator ..
3
Press
t
or
s
to select channel and press
ENT
.
CHL=0 Terminator
Enabled
4
Press
ENT
for two seconds to change from enable to
disable or vice versa.
CHL=0 Disable
Terminator ?
The controller must be reset (e.g., by powering-off then on again, by executing "Reset This
Controller" via LCD interface, etc.) for this to take effect.
