00091577.DOC, Version 1.1
20/25
If you are using controllers with this occupation, you can connect the DMX output of the controller directly
with the DMX input of the first device in the DMX chain. If you wish to connect DMX controllers with other
XLR outputs, you need to use adapter cables.
Building a serial DMX chain:
Connect the DMX output of the first device in the DMX chain with the DMX input of the next device. Always
connect one output with the input of the next device until all devices are connected.
Caution:
At the last fixture, the DMX cable has to be terminated. Plug the terminator with a 120
Ω
resistor
between Signal (–) and Signal (+) in the DMX output of the last fixture.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and
controlled by one master device.
On the rear panel of the LED PSU-5A Artnet/DMX
you can find an XLR-jack (DMX
Out) and an XLR-plug (DMX In), which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master
device and controls all other slave devices, which are to be connected to the master
device via a DMX cable. Connect the DMX OUT jack with the DMX IN plug of the
next device.
Please see further instructions under
Operation.
