00027825.DOC, Version 1.3
23/28
MODE
UP
DOWN
SET UP
DMX MODE
DMX address: 001
DMX512 control
The wires must not come into contact with each other, otherwise
the devices will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR plugs and connectors in order to connect the controller with
the device or one device with another.
Occupation of the XLR connection:
If you are using controllers with this occupation, you can connect the DMX output of the controller directly
with the DMX input of the first device in the DMX chain. If you wish to connect DMX controllers with other
XLR outputs, you need to use adapter-cables.
Building a serial DMX chain:
Connect the DMX output of the first device in the DMX chain with the DMX input of the next device. Always
connect one output with the input of the next device until all devices are connected.
Caution:
At the last device, the DMX cable has to be terminated with a terminator. Solder a 120
Ω
resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX output of the last device.
Addressing the device
The control board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED PSI-1 DMX will respond to the lighting controller.
To define the starting address, you have to be in DMX-mode. Press MODE until
the display indicates d001. In DMX mode, the DMX LED indicator lights up.
Set an address between 001 and 512 via the UP and DOWN buttons.
Controlling:
After having addressed the LED PSI-1 DMX, you may now start operating it via your lighting controller.
