00049912.DOC, Version 1.4
21/28
The maximum drop distance must never exceed 20 cm.
A safety bond which already held the strain of a crash or which is defective must not be used again.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
Fixed Installation
Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1:
Unscrew the four fixation screws in the corners on the front of the cover plate and remove them
with the cover plate.
Step 2:
In the device you will see four 20mm holes for installation, which go through to the mounting
brackets.
Step 3:
Hold the device with the mounting brackets onto the location where the device is to be installed.
Step 4:
Through the four 20mm holes, mark the boreholes with a pen or a suitable tool.
Step 5:
Drill the holes.
Step 6:
Hold the device with the mounting brackets in the desired position and tighten the fixation screws.
Step 7:
Replace the cover plate and tighten the screws.
Do not operate this device with opened cover plate!
DMX512 connection / connection between fixtures
The wires must not come into contact with each other, otherwise
the devices will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a DMX-cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture
or one fixture with another.