00057364.DOC, Version 1.0
22/24
This device then works as master-device and controls the slave-devices, which are to be connected to the
master-device via a stereo shielded cable. Connect the OUT-jack with the IN-plug of the next device.
Press the MODE button to select the SLAVE mode. The devices set in this manner can now be controlled by
the master unit.
Please press the ENTER button to confirm and to exit the SLAVE Mode.
DMX Mode
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED BAR-18 TCL 18x3W will respond to the controller.
Controlling:
After having addressed the LED BAR-18 TCL 18x3W, you may now start operating it via your lighting
controller.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order
to ensure proper transmission on the DMX data link.
Addressing
Press the MODE button until the display shows DMX512 MODE.
Press the ENTER button and the display shows: 001.
Set the desired address via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to select a DMX Channel Mode.
DMX
Channel Selection : Choosing a DMX Channel Mode up to 12 Channal Occupation
After having set the desired addresses and pressed ENTER, you can now choose a DMX Channel Mode. (3
CH, 5 CH, 12 CH).
Set the desired mode via the UP or DOWN buttons.
Press the ENTER button again to confirm and to exit the DMX Mode.
Please see the following DMX protocol graphics for the respective channel values.
3-Channel Mode:
CH 1
CH 2
CH 3
Red (0-100%)
(
0 - 255
)
Green (0-100%)
(
0 - 255
)
Blue (0-100%)
(
0 - 255
)
5-Channel Mode:
CH 1
CH 2
CH 3
CH 4
CH 5
0
: On
1 - 5
: Sound control (7 colors)
6 - 10
: On
Red (0-100%)
(
0 - 255
)
Green (0-100%)
(
0 - 255
)
Blue (0-100%)
(
0 - 255
)
Master Dimmer (0-100%)
(
0 - 255
)
11 - 255
: Strobe (increasing)
