EuroLite LED B-40, Руководство пользователя

Страница: 30 / 36

00124916, Version 1.2 30/36
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAU is indicated on the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronously.
Remote control IR-16
The device must be activated for remote control. For this, select "on" in the menu item irEn . The IR remote
control allows convenient control of the integrated show programs in automatic mode or sound-controlled
mode, and the manual color mode. Press the buttons repeatedly to switch between the programs. The
display indicates the current setting. When actuating a button, always hold the remote control in the direction
of the sensor at the control unit’s front or rear. A direct line of sight between the remote control and the
sensor is required. The IR remote control will only work in stand-alone mode, it will not work in DMX or slave
mode.
Button
Function
On/off
Switch through automatic programs 1-7
Switch through sound-controlled programs 1-7
Pause / play
Decreasing running speed for automatic mode
Increasing running speed for automatic mode
No function
–
Rotation speed adjustment for automatic mode: 0 = slow, 9 = fast
Switches between automatic mode and sound control
No function
Battery
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote control
is not possible.
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the right
and at the same time remove the battery support. For operation, one 3 V button cell
type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
–