00028596.DOC, Version 1.1
21/23
6.7 Call up several chasers continuously
The programs and chasers can be called up individually or combined.
Press all Chaser-buttons and Program-buttons so that their LEDs are lit.
Adjust Masterfader for total output.
Adjust Speed-Fader until the spots react in the desired speed.
The running order is CH1-2-3-4-PR-1-2-3-4. Empty programs will be ommitted.
6.8 Invert the chaser-direction
Press the Prog. <>-button. The Prog. <>-LED is lit. The chaser-direction is inverted.
6.9 Sound-control
If the chaser is to be run sound-controlled, press the Audio-button (LED is lit).
If the chaser is to be run exactly in the bass-beat, pull Speed-fader to minimum and enter the bass-beats by
pressing the Tap Sync-button repeatedly.
6.10 Delete a program
Press and hold the Prog. <>-button and select the desired program number via the Program-button. The
Prog. <>-LED is lit and the Program-LED flashes.
Press and hold the Tap Sync-button and the current Program-button in order to delete the program. The
LEDs flash 5 times.
Press and hold the Prog. <>-button and the current Program-button in order to leave this mode.
6.11 Set all channels to maximum
Press the Full On-button and all channels will be set to their maximum value. As soon as you release the
button, the channels return to their original setting.
6.12 Blackout-Mode
Press the Blackout-button and all devices will be set to Blackout-mode.
7. PROBLEM CHART
PROBLEM
CAUSE
REMEDY
No power.
The power unit is not connected.
Check the connection cable of the
power unit and any extension-cables.
No signal output.
Blackout-mode activated.
Switch off blackout by pressing the
Blackout-button.
Cannot program a program. The Prog. <>-LED is still lit.
Press the Prog. <>-button again and
the Prog. <>-LED is off.
Cannot program a program. The program is full.
Press and hold the Tap Sync-button
and the current Program-button in
order to delete the program.
