www.eurolite.de
21
5
SETUP
1
Remove all packing materials from the shipping box. Make sure that there are no packing remnants at
the fog output nozzle.
2
Unscrew the tank cap and fill the tank with fog fluid. Tightly close the tank again.
3
Connect the included remote control to the jack
REMOTE CONTROL
.
4
Connect the device to the mains with the power plug.
DMX512 Control
The unit features 3-pin XLR plugs for DMX connection.
1
Connect the output of your DMX controller to the DMX input
DMX IN
of the machine with a DMX cable.
2
Connect the DMX output
DMX OUT
of the machine to the DMX input of the next unit in the chain.
Always connect one output to the input of the next unit until all units are connected.
3
At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4
If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
Occupation of the XLR connection:
Installation
Place the machine on a plane surface or mount it via its bracket.
• Install the device in a well-ventilated area. The operation in an insufficiently ventilated room can lead to a
condensation of the fog fluid. The resulting slippery surface can cause accidents.
• Keep a minimum distance of 20 cm around and above the device.
• Furthermore, do not orientate the escape nozzle directly in the direction of the audience's eyes. In order to
create a good effect, there should be a distance between the device and the audience of at least 1.5 m.
• Only install the fog machine on scratch resistant and water resistant surfaces.
• Please make sure that the inclination angle does not exceed 15°.
CAUTION!
Always disconnect from the mains before filling the machine. Only use water-based fluids. We
recommend high-quality EUROLITE fluids. Never add flammable liquids. If fluid gets inside the
machine, have it checked by skilled personnel before it is operated.
