EuroLite AKKU IP Flat Light 3, Руководство пользователя

Страница: 30 / 40

00131183, Version 1.0 30/40
OPERATION
After you switch on the device with the power switch, the device starts running. The display lights up and you
can choose the desired mode via the buttons MENU, ENTER, UP, DOWN, and Function QuickDMX.
The device has two operating modes. It can be operated in stand-alone mode via the control board and the
EUROLITE IR-13 remote control or in DMX-controlled mode via a standard DMX controller and QuickDMX
with suitable wireless transmitter.
Stand-alone mode
In the stand-alone mode, you can do without a controller. Disable QuickDMX and call the desired setting.
Please refer to the instructions under Control Board.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
Set the master device and each slave device to the same transmission channel. For this purpose, press the
ID button on the device, to change the transmission channel and pair the devices.
The selected transmission channel is indicated by the status indicator.
Channel Color
1 Red
2 Green
3 Blue
4 Yellow (red/green)
5 Cyan (green/blue)
6 Magenta (red/blue)
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices.
Set the master device to the desired mode. Set the slave mode (SL.AU) on every slave device. Please refer
to the instructions under
Control Board .
CHARGING
Prior to operating the device off mains for the first time, the rechargeable battery must be fully charged. You
can charge the product using the charging adapter.
1
For charging the battery, connect the device to a grounded mains socket (100 und 240 Volt) via the
enclosed power unit. Charging time is 4 hours. The device may be operated during the charging
procedure.
2 Switch on the device on using the ON/OFF switch. The operating time of the battery depends on the
operating mode and the ambient temperature (max. 16 hours). After the operation, switch the device off.
3 The device features a protective circuit for charging which prevents overload of the rechargeable battery.
However, disconnect the device from the mains after charging. Otherwise there will be a low current
consumption even if the device is switched off.
4 The device will heat up during charging; this is normal.
5 To prevent damage to the battery by deep discharge, recharge a completely discharged battery as soon
as possible. Do not store the unit with the battery completely discharged and regularly recharge the
battery in case of long storage.
Maximum battery run time Recharge time
16 hours 4 hours
Please make sure to close the cap of the charger input after charging in order to prevent the
penetration of humidity and dirt.