00035874.DOC, Version 1.1
10/12
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.
INSTALLATION
Attachment
Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1:
Remove the housing screws on the sides of the device and carefully remove the housing lid.
Step 2:
The 2 holes for the installation are on the baseplate.
Step 3:
Hold the baseplate onto the location where the device is to be installed.
Step 4:
Mark the boreholes with a pen or a suitable tool.
Step 5:
Drill the holes.
Step 6:
Hold the baseplate in the desired position and tighten it.
Step 7:
Connect the device with the mains. (see below)
Step 8:
Replace the housing lid onto the device and tighten the housing screws on the sides of the
device.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
Connection with the mains
DANGER TO LIFE!
The electric connection must only be carried out by a qualified electrician!
Permanent installation is recommended!
