euroline LED Techno Strobe DMX, Руководство пользователя, Страница: 19 / 22

00064378.DOC, Version 1.0 19/22
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the DMX start address 001 on every slave-device.
Analog controller connection / connection between fixtures
The strobe features two ¼“-jacks for connecting several strobes and a one-channel controller by using
instrument leads and mono jack plugs.
Remote control of the strobe is possible via analogue 10V-signals. Every impulse is followed by a flash. We
recommend to use the Eurolite Strobe Controller.
Make sure that you do not connect more strobes like stated in the user manual of the controller.
The occupation of the mono jacks is as follows:
Tip +10 V
Sleeve Ground
OPERATION
After you connected the effect to the mains, the strobe starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, UP, DOWN.
The device has two operating modes. It can be operated in Stand Alone or in DMX-controlled mode.
- STAND-ALONE MODE
•
Setting flash-rate (F-1 – F-9)
•
Setting brightness (C-0 – C-9)
•
Sound Control / Sensitivity (S-0 – S-9)
•
Slave Setting (Add 001)
- DMX MODE (Add 1-512)
Stand-alone Mode
In the Stand Alone mode, the device can be used without a controller. Disconnect the device from the
controller.
Control Board
The Control Board offers several features: you can e.g. set the flash-rate or the starting
address.
Browse through the main menu by pressing MODE. You can change the selection by pressing
UP or DOWN. The functions provided are described in the following sections.
The display shuts off after 30 seconds of inactivity. With the touch of a button it lights up again.