Instruction Manual ZHK
V07-21.0
107/140
RST 156
126
12
150
RST 164
134
12
158
RST 177
149
11
171
RST 187
159
11
181
SPB
RST 156
117
19
149
RST 164
125
19
157
RST 178
139
19
171
RST 187
148
19
180
RST 200
161
19
193
RST 250
211
19
243
Table 16:
Data of pulley types
Changing the working diameter of a variable pulley:
1. Decrease the belt tension.
2. Open the disk circumference distributed screws (position see
3. Twist the outer ring (the outer rings for pulleys with 2 slots) to the desired diameter, observe
4. Fix the Allen screws.
5. Tighten the belts (refer to
chapter 9.2.5 (Re-tensioning of belts)
.
Figure 206:
Schematic structures of a
variable pulley
Figure 207:
Position of the Allen
screws on variable pulleys
After a change of the transmission ratio, the current consumption of the motor must be controlled in
each case. If the consumption is too high, the effective diameter has to be adjusted again. The
nominal current shown on the nameplate must not be exceeded.
Determination of frequency converter caused problems:
It can be determined whether or not problems are caused by the frequency converter by connect-
ing the fan motor directly to mains power supply. Most commercially available frequency convert-
ers have a feature to address these problems.
If the airflow is incorrect and support is required on this matter, please contact EUROCLIMA.
8.3.2 Vibration verification
Check on the quiet running of the fan. There should be no unusual rocking or vibration. Check for
unusual bearing noises. To prevent damage, operation above the permissible vibration values is
forbidden. The maximum permissible vibration speed according to the specifications of the fan-mo-
tor-unit manufacturer must be strictly observed and followed.
On commissioning of the AHU, vibration measurement and / or resonance frequency search in the
entire speed control range must be carried out and recorded in the acceptance report.
Содержание ZHK
Страница 1: ...ZHK INSTRUCTION MANUAL...