15
Make sure, you operated the appliance correctly. If not the servicing by a customer service
technician or dealer will not be free of charge, also during the warranty period. The instructions
about the customer service and conditions of guarantee are in the guarantee booklet.
8.
INSTALLATION INSTRUCTIONS
WARNING!
Refer to "Safety information" chapter.
Before the installation
• Installation of the appliance into a kitchen worktop and its connection to the power mains
may only be performed by an adequately qualified technician.
• Veneer or other finish of the piece of kitchen furniture into which the hob is to be built in
should be treated with heat resistant glue (100°C); otherwise, the worktop finish may be
discolored or deformed.
• Cooking hob is dimensioned to be built into the worktop over a piece of kitchen furniture, with
a width of 600 mm or more.
• After installation, the front two fastening elements should be freely accessible from below.
• Hanging, or wall-mounted kitchen elements should be installed high enough not to interfere
with the work process.
• The distance between the cooking hob and the kitchen hood should be no less than indicated
in the instructions for kitchen hood installation. The minimum distance is 650 mm.
• The distance between the appliance edge and the adjacent tall kitchen furniture element
should amount to no less than 40 mm.
• Use of massive wood decoration plates or boards on the worktops behind the cooking hob is
permitted, if the minimum distance remains the same as indicated in the installation rawings.
• Minimum distance between the built-in cooking hob and the rear wall is indicated on the
installation drawing.
Before inserting the appliance into the opening in the kitchen worktop, the supplied foam
gasket must be attached to the lower side of the glass ceramic (glass) cooking hob (see figure
above). Do not install the appliance without the foam gasket!
8.1 The gasket should be attached to the appliance in the following way:
- Remove the protective fi lm from the gasket.
- Then, attach the gasket to the lower side of the glass, approximately 2-3 millimetres from the
edge (as shown in the figure). The gasket must be attached along the entire length of the glass
edge and should not overlap at the corners. When installing the gasket, make sure that the
glass does not come into contact with any sharp objects.
NOTE!
On some appliances the gasket is already installed!
