Euroboor TUBE.55/AIR, Руководство оператора

Страница: 6 / 33

6
SERVICE
•
Tool service must be performed only by qualified repair personnel. Service or maintenance
performed by unqualified personnel could result in a risk of injury.
•
When servicing a tool, use only identical replacement parts. Follow instructions in the
maintenance section of this manual. Use of unauthorised parts or failure to follow
maintenance instructions may create a risk of injury.
•
When using this machine, you MUST wear ear and eye protection.
1.2 Specific safety information
• Keep your fingers well out of the drill area.
• Avoid touching the drilled core that is automatically ejected by the centering pin when the
working procedure is finished. Contact with the core when it is hot, or if it falls, can cause
personal injuries.
• Always use the safety strap or chain
• The magnetic drilling machine is optimised for use on steel starting with a thickness starting
3 mm with minimal air gap between the magnet surface and the mounting surface. Keep the
air gap to a minimum by cleaning the surface; neglecting to do so this will affect the
performance of the magnets significantly.
• The maximum allowable tip force of the magnetic drilling machine will increase with the
thickness and type of material; air gaps, surface coatings and debris can reduce this value.
• Always place the machine on a surface that is clear of shavings, chips, swarf and surface dirt.
• Keep the magnet clean and free of debris and swarf.
• Do not switch on the machine until it has been mounted and installed according to these
instructions.
• Do not switch on the machine before having checked that the magnetic stand has been
tightened firmly to the mounting surface with both magnet arrays.
• Adjust the table so cutter does not extend into the work piece before drilling. Do not
perform any design, assembly or construction activities on the work piece while the machine
is switched on.
• Before switching on the machine, make sure all accessories have been mounted correctly.
• Always use the recommended speed for the accessories and the material.
• Do not use the machine on the same work piece on which electric welders are being used.
• Use only an appropriate cutting fluid. We offer a range of premium cutting oils and lubricants
which are specially developed and selected for optimum performance and maximum tool
life.
• Do not use liquid cutting lubricants while drilling vertically or overhead. Dip the cutter in
cutting paste or apply an appropriate spray for these applications.
• Do not pour cutting fluid into the reservoir while it is mounted in the bracket.
• Ensure that metal chips or resinous residue cannot lead to blockage of the function.
• In case of jammed cutter disconnect the machine from the air supply, remove the reason for
the jam before turning on the machine again.