Euroboor TUBE.55/AIR, Руководство оператора

Страница: 14 / 33

14
3.2 Prior to use
Please make sure that the contacting surface for the magnet is level, clean and rust-free.
Remove any varnish or primer. When working on materials that are not magnetisable, suitable
fixation devices must be used. When working on steel materials with a material thickness of less than
3 mm, the workpiece must be reinforced with an additional steel in order to guarantee the magnetic
holding power.
Check the machine for possible damage. Before using the machine, you must carefully check
protective devices or slightly damaged components to ensure they are operating perfectly and as
intended.
Check that moving are in perfect working order and do not jam and check whether parts are
damaged. All parts must be correctly installed and fulfill all conditions necessary to ensure perfect
operation of the machine.
Damaged protective devices and parts must be repaired or replaced according to specifications by
EUROBOOR of any authorised EUROBOOR dealer.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
DO NOT let children come into contact with the machine. Supervision is required when
inexperienced operators use this machine.
PNEUMATIC SAFETY
The machine has been designed for a specific air pressure range between 6.3 and 8 bar (90 and 116
PSI). Always check prior to use that the air supply corresponds to this range.
Never modify the air connectors in any way. The standard male 3/8" connector can be exchanged by
the same in case of damage, or replaced by another of a different connection type with an M15
thread. Only use fitting alternative connector pairs suitable for the given air pressure.
Do not abuse the air hoses. Never use the hose on the machine to carry it. Never pull the outlet
connector on the hose from the inlet connector on the machine by pulling at the hose. Keep the air
hoses away from heat, oil, sharp edges or moving parts.
Replace damaged hoses immediately. Damaged hoses may cause air leakage and impact the
performance of the machine.
Useful tips
- Try a few simple projects using scrap material until you develop a ‘’feel’’ for the magnetic
drilling machine;
- Let the machine run in for a period of eight to ten hours before starting with big operations.
Do not load the machine too much during this run-in period;
-
Never use the machine with serious overload;
-
Keep the machine clear from moisture at all times to protect the machine, yourself and
others.