Euroboor LKF.200, Инструкции по безопасности и руководство оператора

Страница: 5 / 10

BEVELLING PIPES
Special optional roller attachment (Art. nr LKF.225 ) allows you to bevel pipes
and curves.
1. To prepare the machine for work on pipes take the slide (#17) off the
machine and replace it with the pipe attachment (LKF.225).
2. Move the housing (#9) to its "zero width of cut" position i.e. when
beveling angle is null.
3. Place machine on the edge of pipe, in such a way that the milling tool
touches the work piece (drawing 2). Then loosen bolts from the rollers
of the LKF.225 and move rollers symmetrically towards the pipe so that
they rest on it. fasten both rollers. You can now adjust required
beveling angle.
Pay special attention to the following points:
- Power supply should be in accordance with all local regulations. Its
capacity to earth electrical loads should be tested prior to work.
- Power supply cable should be protected from damage.
- Precise and tight fitting of the milling head and its inserts.
- Correct adjustment of the milling head to the work piece and tighten bolts.