Euroboor LKF.200, Инструкции по безопасности и руководство оператора

Страница: 4 / 10

START UP AND OPERATION
LKF. 200 comes in a ready-to-use state. The only operation that needs to
be carried out is adjusting it to workpiece thickness and the beveling angle.
Precise instructions how to do it are given below in point 5.
Plug machine into mains. Both the plug and the socket must be earthed. Lift
the machine and place it vertically on its horizontal slide, on the edge of your
workpiece, which should be on your right hand side.
Make sure that the tool does not touch the workpiece. You can now turn the
machine on by pressing main switch (#53) to position "I". To switch machine off
press switch (#53) to position "O".
You can now start the motor pressing switch (#54, button "I") what will be
signaled with an amber light coming on (#52). To stop the motor press switch
(#54) again (button "O").
Start sliding the machine slowly to the right, until such a moment that the
tool starts to cut steel but remember - the direction of feed is marked on the
spindle housing (#9). The feed rate depends on the thickness of steel which is
being beveled and on the composition of that steel.
Most steels can be beveled with just one pass.
If the operator attempts to mill too fast and too thick, the overload red
indicator (#51) will start flashing and if motor is loaded even harder power will
be cut off. To start the machine again move the tool away from beveled edge,
than press button "O" switch (#54), and after few seconds you can start the
machine again by pressing button "I" switch (#54)
Operator is permitted to use the machine at the brink of the cut-off point with
overload light coming on and off, but the temperature of the motor should not
exceed 85°C. Higher temperature can permanently damage rotor.
LKF. 200 is designed to work under full load for around 1 hour, after which it
should cool down for about 15 minutes. The motor will not cool down running
free, but it will get even warmer.
Always wear protective glasses!
Inspect the condition of milling inserts regularly and change them when
worn!
Stop machine, if any abnormal signs occur!
Always unplug machine from power supply during any work on
the tool, when adjusting angles or any other work on it.
All repairs should be carried out by authorized service only.