20
2.
Gently feed in setting screw with supplied Allen key 2.5 until slight resistance is encountered.
Follow your way down adjusting all setting nuts and screws
3.
Operate the slide up and down a few times to test the movement and make any further
necessary adjustments. Try to ensure that all the screws are exerting a uniform pressure on
the slide from top to bottom. A perfectly adjusted slide will operate freely up and down
without any sideways movement
LUBRICATING THE FEED TRAVEL
The feed travel should be lubricated periodically with grease to ensure smooth operation.
-
Raise the motor unit to the highest position possible
-
Lubricate the dove-tail guide way at both sides
-
Lubricate the gear rack
After repeated use, the gear rack may become loose. If necessary, adjust the 5 self-locking set
screws at the left side. Tighten screws in series until the gear rack moves freely in the dove-tail guide
but does not allow the motor to wobble.
REPAIR, MODIFICATION AND INSPECTION
Repair, modification and inspection of Euroboor magnetic drill stand must be done by EUROBOOR or
an EUROBOOR authorized dealer. The spare parts list will be helpful if presented with the machine to
the Euroboor dealer for service when requesting repair or other maintenance.
Euroboor machines are constantly being improved and modified to incorporate the latest
technological advancements. Accordingly, some parts (i.e. part numbers and/or design) may be
changed without prior notice. Also, due to Euroboor's continuing program of research and
development, the specifications of machines are subject to change without prior notice.
WARNING:
Since accessories, other than those offered by EUROBOOR, have not been tested
with this product, use of such accessories with this tool could be hazardous. To reduce the risk
of injury, only EUROBOOR recommended accessories should be used with this product.
Consult your dealer for further information on the appropriate accessories.
www.fnglob.pl
