Euroboor ECO.50S, Руководство оператора

Страница: 18 / 31

18
We need to point out that this is only an indication and not a certainly that the magnet will not
release from the material. Euroboor accepts no liability ensuring from the magnet indicator not
functioning or functioning poorly.
Make sure that the magnet attaches tightly to the work piece before turning on the motor unit of the
magnetic drilling machine. Euroboor magnets have 2 coils; make sure that both coils are in contact
with the material. Do not connect any other machines to the electrical outlet the magnetic drilling
machine is plugged into, as it may result in the loss of magnetic force.
Always use the safety chain included. Drilling above your head is extremely dangerous and is not
recommended. For the use of magnetic drilling machines on pipes, not-flat or non-magnetic
materials, we refer to our brochure or our website www.euroboor.com where several vacuum
tightening systems and pipe clamping systems are mentioned.
4.5 Switching motor on and off
The motor unit can only be switched ON when the magnet is activated. To switch the motor ON,
press the green button with marking “I”. To switch the motor OFF, press the red button with marking
“O”.
4.6 Temperature control
The ECO.50S is equipped with an all-time electronic temperature protection. If the temperature of
the motor unit runs up to 70 Degree Celsius the motor unit will stop. After a few minutes it can be
started again.
When it is possible to start the motor again, let the motor run idle at full speed for a couple of
minutes to let the motor cool down more in an efficient way.
4.7 Tool lubrication
IN HORIZONTAL APPLICATIONS
In order to use the lubrication system, the tank must be filled with a cutting fluid or oil
1. Make sure the flow regulator is closed
2. Unscrew the cap
3. Fill the container with cutting fluid or oil
4. Screw the cap back on
•
Adjust the fluid flow as required using the flow regulator;
•
Add more cutting fluid if the shavings (metal chips) become blue.
0800 536 774
sales@gwsnz.co.nz
www.globalweldingsupplies.com
13 Patiki Road Avondale, Auckland 1026