www.euroboor.com
16
3.2 Adjusting the bevel depth
Note:
For adjusting the bevel depth, the supplied hex key is required.
Step 1:
Loosen the two bolts that lock the guiding plate in place, using the hex key.
Step 2
: Turn the guiding plate clockwise or counter-clockwise, the bevel depth can be
adjusted. The depth indicator on the side of the machine shows the set depth of the bevel.
This can be set in-between 0,1 and 1,0 mm.
Step 3
: Tighten the two bolts that lock the guiding plate in place, using the hex key.
Step 1
Step 2
Step 3
