www.euroboor.com
20
Switching on
Press the On/Off trigger switch to start the machine. The anti-kickback and breakthrough torque
control provides a “slow start”: the machine needs a couple of seconds to reach its set running speed.
The On/O
ff trigger switch can be locked in the “on” position by pressing the lock pin while the machine
is running.
Controlling running speed
This machine is equipped with variable speed control. The speed adjustment wheel can be rolled down
to increase the machine speed and up to decrease the machine speed.
Switching off
If the lock pin is not engaged, release the On/Off trigger switch. If the lock pin is engaged, squeeze and
release the On/Off trigger switch.
WARNING:
The milling head of the machine needs a couple of seconds to come to a
complete standstill after the machine has been switched off. Be careful for any chips that
may be released by the rotation and make sure that nothing touches the moving parts.
Overheat protection
This machine is equipped with an overheat protection which switches off the motor when running hot.
Allow the machine at least 5 minutes too cool off and let it run idle for another couple of minutes
before resuming work.
