EURO EP900ISX2, Инструкция по эксплуатации

Страница: 5 / 13

(3) INSTALLATION
This Rangehood must be placed at a distance of 65cm minimum from the
cooking surface of a cooker/hotplate and 120cm minimum from the
cooking surface of a BBQ.
3.1
The ceiling must be able to bear at least 40kgs weight. Cut a
170mm round hole in the ceiling.
3.2
To fix the hanging board, drill 12 holes in the ceiling using the
plate as a template (refer to pic 2). Use the 12 ST6x40mm screws
and fittings to fix the hanging board on the ceiling.
3.3 Use 8pcs of M4x10 screws and M4 nut with washer to connect
the angle iron onto the corners of the hanging board (refer to pic 2).
3.4
Calculate the length of the angle iron (refer to pic 1) and use
16pcs M4x10 screws and M4 nut with washer to connect one length
of angle iron to another. The overlap length of angle iron must not
be less than 100mm.
3.5
Fit one side of the flexible duct
(not included with the
Rangehood)
through the 170mm hole in the ceiling (refer to pic 3).
3.6
Use 4pcs of ST4x8 screws to attach the internal chimney onto
the hanging board. Slide the external chimney over the internal
chimney and fit one 1pcs of ST4x8 screw to stop it from falling
down (refer to pic 4).
3.7
Attach the plastic outlet to the top of the Rangehood using
4pcs ST4x8 (refer to pic 5).
3.8
With assistance, hold up the Rangehood body and attach it to
the angle iron frame using 16pcs M4x10 screws and tighten them
securely (refer to pic 6).
3.9
Lower the flexible pipe onto the plastic outlet. Carefully
remove the screw from the external chimney and lower it down into
place. The installation is now finished, refer to pics 7 & 8.