EURO EG800FS2, Руководство по установке

Страница: 24 / 32

24
Hot Plate Ignition Failure
• Check alignment of burner holes to electrode.
• Check aeration sleeve for adjustment for gas type,
location and ambient conditions.
• No spark, check ignition box failure or power supply.
Before Leaving
• Check all connections for gas leaks with soap and
water. DO NOT use a naked flame for detecting
leaks. Ignite all burners to ensure correct operation
of gas valves, burners and ignition.
• Turn gas taps to low flame position and observe
stability of the flame. When satisfied with the cooker,
please instruct the user on the correct method of
operation.
• In case the appliance fails to operate correctly
after all checks have been carried out, refer to the
authorised service provider in your area.
OVEN BURNER (fig. 20)
The burner is installed on the oven base and is covered
by the bottom plate which must always remain in that
position during oven operation,
To adjust the primary air, is performed when the
burner is ignited, by adjusting the sleeve (B) and
unscrewing screw (A). Lock screw (A) in place once
the adjustments have been made.
CHANGING THE FLEXIBLE GAS HOSE
In order to guarantee that the gas hose is always in
excellent condition we strongly recommend changing
it on the date you will find printed on it.
GAS CONVERSIONS
REPLACING THE INJECTORS
Our burners can be adapted to different types of gas by
simply installing the injectors suitable for the gas you
want to use. To help the installer, the table on page 23
gives the burner nominal heat input, injector diameter
and operating pressure of the different gas types.
INSTRUCTIONS FOR THE INSTALLER
20
21
Comply with the following instructions:
Injector replacement - Hob burners.
To change the injectors on the hob, remove the burner
cup and head and with a 7 mm Ø socket spanner
replace them (fig. 21).
Injector replacement - Oven burner.
Remove oven base. Remove screw (D) (fig. 20) which
will release burner and give access to the injector (C).
Unscrew injector and replace it. Replace burner and
replace screw (D).
After having replaced the injectors, it will be
necessary to proceed with burner adjustment as
explained in the previous paragraphs.
REPLACING THE ELECTRICAL COMPONENT
• The rear protection will have to be removed in order
to change the electrical heating elements, spit
motor, terminal board and power cable.
• If you have to change the power cable (see
TECHNICAL FEATURES paragraph ), always keep
the earth wire longer than the phase wires and,
in addition, follow all the instructions given in
the “ELECTRICAL CONNECTION” paragraph.
• To change the oven lamp see the instructions
REPLACING THE OVEN LAMP paragraph .
• To change the lamp holder, the spark generator and
the spark electrodes, the work top has to be removed
as indicated in the paragraph « REPLACING THE
TAPS» .
• To change the programming accessory, the
thermostat, the commutator and the warning lights,
remove the front panel by unscrewing the three
fixing screws which lock it to the front frame.
19A