EURO EG800FS2, Руководство по установке

Страница: 16 / 32

16
INSTRUCTIONS FOR THE USER
OVEN DOOR REMOVAL
The oven door can be removed to give easier access to
the oven when cleaning. To remove, proceed as follows:
• Open the oven door and insert rivet or nail (R) in the
hole (F) of the hinge (fig. F).
• Partially close the door, forcing it upwards at the
same time to free stop tooth and hinge sector.
• Once the hinge is free, pull the door forwards tilting
it slightly upwards to free sector.
• To reassemble proceed in the reverse order,
paying attention to the correct position of sectors.
REPLACING THE OVEN LAMP (fig. 13)
Ensure the appliance is switched off before
replacing the lamp to avoid the possibility of
electric shock..
In the event oven lamp need replacing, the new lamp must
comply with the nominal data indicated on page 23 and
must be resistant to high temperature (300°C).
Draw out the side guide rails as described above.Then,
remove the glass protection cap (V) from the bulb socket,
lifting it with a screwdriver placed between the cap and the
oven wall and replace the lamp (L). Fit the accessories
back in reverse order.
13
F
Some problems can be caused either as the results of simple maintenance operations or by incorrect selection
of settings. Prior to contacting a Service Centre please check the following chart.
PROBLEM REMEDY
The appliance is not working • Make sure the gas cock is open
• Check the plug is in
• Check that the knobs are set correctly for cooking and then repeat the
operations given in the handbook
• Check the electrical system safety switches (RCD). If there is failure in
the system call an electrician in.
The electric oven is not working • Check that the programmer accessory, if there is one, is on the manual
position and then repeat the operations described in the manual
The thermostat is not working • Contact Service Centre..
The electric thermostat warning
light does not switch on during use
• Turn the thermostat round to a hotter temperature
• Turn the selector round to a different function
The oven light does not switch on • Make sure the lamp is firmly screwed in place
• Buy a lamp for high temperatures at one of our Service Centre
and fit it following the instructions REPLACING THE OVEN LAMP
paragraph .
Warning: Servicing should be carried out only by authorised personnel.
TROUBLESHOOTING