Dome address setting
The control commands contain target dome’s
ID. The dome only reacts to the command sent
to its own address or broadcast address.
Each dome should be assigned an address.
Four kinds of IDs are applicable for domes:
1. Hard ID:
Hard ID is set via DIP SW2 can not be
changed from OSD menu. Hard ID ranges
from 1 to 254.
2. Programmable ID:
Set all 8bits of SW2 to ON to activate soft
address. Input 10-bit camera SN number,
and then set dome ID by controller (The
dome SN number can be found on the side
of the camera or on the package and user
manual.).
3. Broadcast ID:
Broadcast ID is programmable.
When broadcast ID is available, all domes
connected to the control bus will react to
the command. The default broadcast ID is
255.
SW2 is for dome ID setting. The setting is
strictly according to binary system. If you
are not familiar with binary system please
look up the address setting chart.
Address setting chart
ID
B1
B2
B3
B4
B5
B6
B7
B8
1
ON
2
ON
3
ON
ON
4
ON
5
ON
ON
6
ON
ON
7
ON
ON
ON
8
ON
9
ON
ON
10
ON
ON
11
ON
ON
ON
12
ON
ON
13
ON
ON
ON
14
ON
ON
ON
15
ON
ON
ON
ON
16
ON
17
ON
ON
18
ON
ON
19
ON
ON
ON
20
ON
ON
21
ON
ON
ON
22
ON
ON
ON
23
ON
ON
ON
ON
24
ON
ON
25
ON
ON
ON
26
ON
ON
ON
27
ON
ON
ON
ON
28
ON
ON
ON
29
ON
ON
ON
ON
30
ON
ON
ON
ON
31
ON
ON
ON
ON
ON
32
ON
33
ON
ON
34
ON
ON
35
ON
ON
ON
36
ON
ON
37
ON
ON
ON
38
ON
ON
ON
39
ON
ON
ON
ON
40
ON
ON
41
ON
ON
ON
42
ON
ON
ON
43
ON
ON
ON
ON
44
ON
ON
ON
45
ON
ON
ON
ON
46
ON
ON
ON
ON
47
ON
ON
ON
ON
ON
48
ON
ON
49
ON
ON
ON
50
ON
ON
ON
51
ON
ON
ON
ON
Soft
Add
ON
ON
ON
ON
ON
ON
ON
ON
EVC-TP-SO453ARW, EVC-TP-SO448AN
www.eurovideo-cctv.com
-
40-
