■
ZONE
<Main Menu>
<Auto Running>
<Zone>
A zone is an area between two points. User can set a
zone and scan it automatically.
<Zone> is similar to <Cruise> except user can
assign a title for a ZONE. Whenever the camera
moves into the zone, the title will display on the
screen to alert the operator.
NOTE: Camera scans horizontally only. User can
set up to 8 zones.
<Zone Number.>
Display current zone number. Values are 001~008.
Pan right then tilt up or down to select desired
value.
<Title>
Set the zone title. Select the desired letter or
number. Repeat above procedure to complete the
title editing.
<Left Limit>
Set the position of the first point. The following
picture shows the setting menu.
The setting procedure is the same as setting
preset. Move the camera to a particular position
and call preset 1 to save.
<Right Limit>
Set another point’s position. Set it in the same way
as <Left Limit>
<Remove Current>
Delete current zone setting.
<Speed> Set the scanning speed
(camera movement speed). Value ranges from 001
to 255, the greater number represents the higher
speed. Pan right to select, tilt up or down to change
value.
RUN To start scanning the current zone
(001~008).
BACK Back to upper menu level.
<Pan Speed>
Setup pan speed
EVC-TP-SO453ARW, EVC-TP-SO448AN
www.eurovideo-cctv.com
- 35
-
- 35
-
Zone Number.: 001
Title: 000000000000000
Left Limit
Right Limit
Remove Current
Speed
：
：
：
：
001
Run
Back
Call Preset 1 To
Confirm......
