ADDITIONAL IMPORTANT SAFEGUARDS cont.
OPERATING INSTRUCTIONS cont.
Important:
Please note that bristles may
break through thin towels. We recommend
that two (2) towels, laid one on top of the
other be used. This will ensure that the
brush bristles do not break through and
that the towels will be sufficiently absorbent
and retain as much dirt as possible.
Very Important
:
When installing the
towels to the floor brush, ensure that the
towels do not cover the front and the back
of the brush. (See fig. E)
Attaching a Towel to the
Floor Brush
100% white terry cloth towel can be fitted
on this brush, so as to absorb the dirt and
protect delicate surfaces.
Fig. C
Fig. B
1. Prepare white terry cloth towel:
size 8” x 17” as shown in Fig. A.
2. Place the brush on top of the towel.
5. Place the corner under the cloth
holder as shown in Fig. D.
Fig. D
Open
Open
Fig. E
Fig. A
Warning:
Always keep unit in upright
position when in use. Do not lie flat on
the floor or turn upside down when in
use. Inverting the unit or placing flat on
the floor may cause hot water to exit
from the hose and cause injury.
1. To avoid circuit overload,
do not
operate
another appliance on the same socket
(circuit) when using this unit.
2. If an extension cord is absolutely
necessary, a 15 ampere 14 gage cord
should be used. Cords rated for less
amperage may overheat. Care should be
taken to arrange cord so that it cannot be
pulled or tripped over.
3.
Do not
leave unattended when the system
is connected to a power supply/electrical
outlet.
Note:
We recommend that you drain
the water tank after every use.
4. Fold the other side of the towel as
shown in Fig. C.
Caution:
Upon initial use, the steam will be mixed with water,
hot enough to scald. Ensure that the floor brush is
resting on the floor or the hose handgrip is directed
away from user when steam switch is turned on. Never
direct the nozzle or brush end of the unit toward
yourself or anyone near you.
Important User Information
Please note that this steam cleaner has a “
flow through injection
” type
boiler and is
not
a pressurized system. It will take approximately 45-90
seconds for the steam injector to heat up and the “
steam ready light
” to go
off. Once the steam ready light has gone off, push the steam switch on the
handgrip to the “On” position (I) in order to start the steam flow. Steam
power will steadily increase during the first four (4) minutes of use, after
which time steam output will stabilize. Some steam will
condense
around
the floor brush when in use and will cause hard surfaces to become wet
during the cleaning process,
this is normal.
Warning:
This appliance is equipped with a grounded-type
3-wire cord (3-prong plug). This plug will only fit into
an electrical outlet made for a 3-prong plug. This is a
safety feature. If the plug should fail to fit the outlet,
contact an electrician to replace the outlet. Do not
attempt to defeat the safety purpose of the
grounding pin, part of the 3-prong plug.
6. Place the towel around the brush,
and repeat folding the towel as shown
in Fig. E. When folding the towel,
leave some slack.
Do not
pull tightly
around the brush, leave some
looseness.
2
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
3. Fold the towel as shown in Fig. B
7
