6. While holding the thread, pass it between the
tension discs and pull the thread down to make
sure that it is properly located in between the
tension discs. (Fig. 11)
7. Turn the handwheel towards you until the lower
looper is at the far right. (Fig. 12)
8. Thread the looper area of the machine following
the yellow coded thread guides at positions “4 to
7”. (Fig. 13)
Note: Use the tweezers provided in the accessory set
to help in threading the looper.
9. Grasp the thread with the tweezers approximately
1 1/2 inches (4 cm) from the thread guide “7”.
(Fig. 14)
10. Pull the thread with the point of the tweezers
slightly under and to the left of the threading guide
“8”. (Fig. 14)
11. Pull the thread up and into the thread guide “8”.
(Fig. 14)
12. Pass the thread behind and over the left end of
the lower looper at position “9-A”. (Fig. 15)
13. Then pull it downward gently so that it will slip into
the slot in the looper at position “9-B”. (Fig. 16)
14. Pick up the thread and pass it through the hole in
the right end of the lower looper “10”. (Fig. 16)
Note: Use the tweezers provided in the accessory set
to help in threading the looper.
15. The thread should be positioned in the groove of
the lower looper.
16. Pull about 4 inches (10 cm) of thread through the
looper and place it over the top of the upper looper
and to the back of the needle plate. (Fig. 17)
Fig. 11
☞
Fig. 12
☞
Fig. 15
Fig. 13
Fig. 14
Fig. 16
Fig. 17
15
