3
Getting To Know Your
Hand Held Hard Surface Steam Cleaner
1.
Nozzle
2.
Variable Steam Adjustment
3.
Safety Cap
4.
Trigger Button
5.
Trigger Safety Lock
6.
Handle
7.
Main Unit
8.
Power Cord
9.
Heating Indicator Light
10. Steam Ready Light
Technical Specifications
Voltage: 120V., 60Hz.
Power: 1,000 Watts
Water Capacity: 10 oz. (300 ml)
*Illustrations may differ from actual product.
11. Nylon Detail Brush (x2)
12. Hose
13. Angle Adapter
14. Concentrator Nozzle
15. Window Squeegee/Steam Diffuser
16. Measuring Cup
17. Funnel
18. Cleaning Cloth
19. Brass Detail Brush(x2)
20. Storage case (not shown)
8
Operating Instructions
Brass Detail Brush
•
Use the brass detail brush to
clean ovens and hard metal
surfaces.
•
To use, attach the brass detail
brush onto the concentrator nozzle.
(Fig. 9)
Using the Steam Cleaner with the
Hose
To attach the hose to the main unit:
•
Align the raised arrow on the end of
the hose with the single white line
on the ring of the snout. (Fig. 5 & 6)
•
Push the end of the hose onto the
nozzle until it stops against the
•
To attach the concentrator nozzle,
window squeegee/steam diffuser,
angle adapter or detail brush to the
hose, follow the instructions in the
corresponding sections.
Bathroom Areas
appliance.
•
To lock the hose in place, turn it 90
degrees clockwise so that the
raised arrow mark aligns with the
two white lines on the ring of the
snout. (Fig. 6)
To clean the bathtub or shower area,
use the nylon detail brush for grout,
shower door tracks, hard to get areas
and heavily soiled areas. Allow plenty
of time for the heat to penetrate the
surface. This is especially helpful in
the shower area if there is tile or grout.
To clean the toilet, use the nylon detail
brush. Use a terry cloth towel or paper
towel to wipe up excess moisture and
residue.
To clean the sink and faucets, use the
nylon detail brush.
Soap Scum
Soap scum dissolves almost
immediately under a combination of
heat and moisture. Rinse the surface
with a small amount of water
afterwards or go back over it once
more with a clean terry cloth towel.
Note:
Soap scum sometimes will
develop a hard surface from water-
borne minerals. If this is the case, use
the nylon detail brush first to break up
this surface - or spray or wipe first with
lemon, vinegar or seltzer soda water to
soften the minerals. Moving too slowly
can dry out the soap scum and cause it
to granulate on the surface. The
surface will have a gritty feel. If this
happens, apply vapor to the surface
with the nylon detail brush again and
re-clean.
Nylon Detail Brush / Angle
Adapter
• Both the angle adapter and the
nylon detail brush can be used on
the concentrator nozzle.
• To use, push either of the
attachments onto the end of the
concentrator nozzle. (Fig. 8 & 9)
Angle Adapter
Nylon Detail Brush
Fig. 8
Fig. 9
