OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS cont.
Cleaning & Changing the
Dust Cup Filter
Warning:
Always unplug from
electrical outlet before opening the dust
cup (container).
Note
: Dust cup filter must be used
when operating the hand vacuum.
3. To use the flexible hose, push the
end of the hose into the suction
hole, then attach the desired
accessory to the other end of the
flexible hose, as shown below.
Fig. 3
3. Empty the dust from the dust cup
(container). (Fig. 3)
4. Rinse the dust cup filter in cold water
and then wait 24 hours until it dries
completely before replacing back
into the dust cup (container).
(Fig. 4 & 5)
5. When the dust cup filter is completely
dry, replace the dust cup filter carefully
back into the dust cup (container).
6. Attach the dust cup (container) to the
Hand Vacuum.
Fig. 4
Fig. 5
Warning:
Always unplug the unit from
electrical outlet before opening the Dust
Cup (container).
Important
: Do NOT
use the hand
vacuum without the dust cup filter in
place.
Assembling the Hand Vacuum
1. To open the dust cup (container), push
the dust cup release button and pull
out the dust cup. Verify that the dust
cup filter is inside, then attach the dust
cup (container) to the hand vacuum.
1. To open the Dust Cup (container),
push the dust cup release button
and detach the Dust Cup
(container). (Fig. 1)
2. Remove the dust cup filter. (Fig. 2)
Warning
:
After each Use - Always
remove and empty the Dust Cup Filter.
Fig. 1
How To Operate Your Hand Vacuum
1. Hold the hand vacuum firmly in
your hand by the Handle.
2. Push the On/Off Power Button to
“On” position.
3. Start vacuuming.
2. To attach the crevice tool or
upholstery brush to the Hand
Vacuum, push desired accessory
into the suction hole, as shown
below.
CAUTION
:
The Hand Vacuum is a
very powerful unit. Make sure that you
hold it firmly, otherwise it can slip out of
your hand and cause injury.
Fig.2
CAUTION:
The suction hole must be
open, free of any obstructions at all
times. Otherwise, the motor will overheat
and could become damaged.
Please Note
:
The Dust Cup Filter is
washable. It should, however, be
replaced every three (3) months to
ensure peak performance of your
vacuum.
Important
: Make sure that Dust
Cup Filter is completely dry before
re-installing back in the hand
vacuum.
4
3
