background image

Maintenance & Care 

For best cleaning results, the dust bag should be changed often. The use of powder carpet 
fresheners can decrease the effectiveness of the dust bag filtering system by clogging the 
bag and not allowing air to flow though properly.  We recommend that hard objects, pins, 
broken glass, paper clips, etc. be picked up from the floor before vacuuming.  Although, your 
vacuum will pick them up, they could do severe damage to the vacuum.
Use genuine EURO-PRO dust bags, belts and filters only, to insure top performance from 
your vacuum.

1. Changing the Dust Bag

:

A)  Unplug cord from wall outlet.
B) Pull hard-shell body cover (8) off by releasing the latch 

(11)  on top of the cover.

C) Remove the old dust bag by holding the cardboard 

support and pull towards you from the bottom first and 
next from the top.  Remove carefully to avoid dust/dirt 
spilling from dust bag.

D) Take a new dust bag and while holding the cardboard 

support push the bag over the opening of the dirt 
discharge tube until it is seated against the rear of the 
enclosure.

E) Make sure that the entire bag is inside the hard-shell 

housing, before closing outer cover.  Always check the 
filter every time you change the dust bag. 

F) Once the new dust bag is in place, re-close the hard 

shell front cover by aligning the bottom locking tab 
with the slot in the body, close cover slowly allowing 
the mid locks to engage, then snap top in place.  The 
latch will self lock.

Exhaust Filter

2. Changing the Filter

:

A)  This is best done while changing the dust bag.
B) Follow instructions for changing the dust bag.  Once 

dust bag has been removed, peel off exhaust filter, 
located behind the dust bag on unit body.

C) The filter is held in place by Velcro strips and is easily 

removed and replaced for cleaning.

D) To clean filter rinse in warm, soapy water.  Filter must 

by completely dry before re-installing into your 
vacuum.  To re-install, press filter back onto Velcro 
strips.

NOTE: DO NOT OPERATE VACUUM WITHOUT FILTER IN 

PLACE.

E) Once filter has been replaced, follow instructions for 

installing dust bag and closing front hard shell cover.

3

Содержание EP700









Отзывы: