Eureka MAGNUM HDK, Руководство пользователя

Страница: 31 / 90

32
CONTROL THE HYDRAULIC OIL
LEVEL IN THE TANK
EVERY 100 HOURS
Turn off machine and remove key pos.1
Remove oil level rod pos.4 and verify that the oil level is in
the space where the dipstick is squashed.
If it is low it should be refilled.
NOTE: DO NOT USE DIFFRENT OILS FROM THE
ONES INDICATED.
HYDRAULIC OIL FILTER
REPLACEMENT AFTER THE
FIRST 100 HOURS, THEN AFTER
1000 HOURS
Turn off machine and remove key pos.1
Slowly unscrew cap pos.2
Slowly lift up oil filter cartridge pos.3, wait that all the oil
flows out and the replace it.
Do not dispose used oil and/or filters into the
environment
HYDRAULIC OIL CHANGE
AFTER 2000 HOURS
Open if closed the door and lower the hopper.
Turn off machine and remove key pos.1
Remove oil level rod pos.4
Have an adequate container and position it under the oil tank
Remove the drainage cap pos. 4 and empty out oil.
Fit cap back on drainage. pos. 7
Refill tank, superior to the oil level rod pos.4 ( total tank +
oil plant = liters 25)
Insert the oil level rod.
Start engine with key switch pos.1
Carry out a few hopper raising and closing maneuvers,
rotation of the main brush, and move with the sweeper
forward und reverse.
Turn off machine and remove key pos.1
Recheck the level of the oil and close up everything again.
NOTE: DO NOT USE DIFFRENT OILS FROM THE
ONES INDICATED.
CLEAINING OF THE HYDRAULIC
OIL EXCHANGER Remove hood pos.5 of the Hydraulic oil exchanger.
Blow periodically (every 100 hours) with compressed air the
heat exchanger pos.6 keeping a proper distance from the
wings in order not to bend them.
BATTERIE ELECTROLYTE
LEVEL CONTROLLO
Lift rubber carpet
Remove platform pos.8
remove battery caps pos. 9
verify that the level of the liquid is 10 mm superior then the
height of the internal plates.
reclose all