Euphonix TT007 Operation Manual
29
Appendix
A.1
Frequently Asked Questions
Why does my TC generator not run when I hit play?
•
It is not configured as a Master or Slave.
•
It is set to video resolve but no video sync is being received
Why does the master machine selection keep shutting off?
There can only be one master machine, so when you configure a new port as Master,
any port previously designated as Master automatically toggles OFF. This may happen
unintentionally while passing through the master selection for a port while intending to
configure it for some other setting.
Why does the video sync selection keep shutting off?
The TcR (Timecode Reader) and Video sync are mutually exclusive, i.e., the TT007
can only use one of them as a reference. When either is selected, the other automatically
toggles OFF.
Why does the TC reader keep shutting off?
See above.
What is the difference between a Master, Slave and Controller?
See
Explanation of Controllers
on page 30.
Why are my presets gone?
Replacing the system software Eprom and/or selecting
MEM CLEAR
from the Service
submenu erases system presets.
Why is there no timecode at the desk but I see it on the TT007 dis-
play?
The Timecode Generator is not set to Slave. TC should be set to slave in all cases unless
it is configured as a master.
Why won’t my slave chase (P2-to-P2 mode)?
•
Check that all machines are video referenced.
•
Be sure that you have selected an appropriate slave type in the Type sub-menu.
•
Be sure the device does not require a controller-to-controller Tx/Rx pin swap.
See
Cable Pinouts
on page 41.
