SECTON 2
HARDWARE INSTALLATION
This section gives you a step-by step procedure on how to install your system. Follow each
section accordingly.
2-1
Jumper Settings
Please refer the following figures for the locations of the jumpers on the mainboard.
2-1.1 CMOS Clear Setting
JP1 Clear CMOS
Clear CMOS
Normal
(Default)
To clear CMOS, please follow the steps below:
1. Power off the system and unplug the chassis AC power cord.
2. Short JP1 at pin 2-3 for few seconds.
3. Set JP1 back to its Normal position at pin 1-2.
4. Plug the AC power cord to the chassis.
5. Power on the system and load the BIOS setup default.
IEZ / ITZV4 Motherboard User’s Manual
2-1
