U2836 Operation Manual Chapter 3 Introduction to [MEAS DISP]
11
3.1.1
Test function
In a measurement period, U2836 can test two parameters for an impedance
component. Parameters that can be tested are as follows:
Primary parameters
|Z| (Module of impedance)
L (Inductance)
C (Capacitance)
R (Resistance)
G (Conductance)
Secondary Parameters
D (Dissipation factor)
Q (Quality factor)
Rs (Equivalent Series Resistance ESR)
Rp (Equivalent Parallel Resistance)
X (Reactance)
B (Admittance)
θ
(Phase Angle)
Test results of primary and secondary parameters are respectively displayed in
two lines in the form of upper-case characters. The primary parameter displays in
the upper line while the secondary parameter displays in the lower line.
Operation steps for setting test function:
1)
Move the cursor to FUNC zone, the following soft keys will be displayed on the
screen.
Cp—D
Cp—Rp
Cs—D
Cs—Rs
More 1/3
2)
Select and press a softkey to set test function. If the softkey you need is not
displayed on the page
，
press More to display the following softkeys.
Ls—Q
Ls—Rs
Lp—Q
Lp—Rp
More 2/3
3)
Select and press a softkey to set test function. If the softkey you need is not
displayed on the page
，
press More to display the following softkeys.
R—X
Z—
θ
r
Z—
θ
°
G—B
More 3/3