EUCHNER CTP-I.-AS, Руководство по эксплуатации

Страница: 19 / 28

19
2543028-02-01/21 (Translation of the original operating instructions)
Operating Instructions
Transponder-Coded Safety Switch CTP-I.-AS
EN
13. Technical data
NOTICE
If a data sheet is included with the product, the information on the data sheet applies.
13.1. Technical data for safety switch CTP-AS
Parameter Value Unit
min. typ. max.
General
Material
- Switch head
- Switch housing
Die-cast zinc
Reinforced thermoplastic
Installation orientation Any
Degree of protection IP67/IP69/IP69K
(screwed tight with the related mating connector)
Safety class acc. to EN IEC 61558 III
Mechanical life 1 x 10
6
operating cycles
Ambient temperature at UB = 24 V -20 - +55 °C
Actuator approach speed, max. 20 m/min
Actuating/extraction/retention force at 20 °C 10/20/20 N
Locking force F
max
1) 3,900 N
Locking force F
Zh
1)
acc. to EN ISO 14119 F
Zh
= F
max
/1.3 = 3,000 N
Weight Approx. 0.42 kg
Connection Plug connector M12, 4-pin
For the approval acc. to UL the following applies Operation only with UL class 2 power supply, or equivalent measures
Resilience to vibration Acc. to EN 60947-5-3
EMC protection requirements Acc. to EN 60947-5-3
Ready delay - - 1 s
Risk time - - 260 ms
Turn-on time - - 400 ms
Frequency band
120 … 130 kHz
Solenoid
Auxiliary voltage 24 +10%/-15% (PELV) V DC
Current consumption with auxiliary voltage 400 mA
Duty cycle 100 %
AS-Interface data EA code: 7 ID code: B
AS-i operating voltage 26.5 - 31.6 V DC
Total current consumption from AS-i CTP-..-AS.A - - 450
mA
CTP-..-AS.B - - 50
Valid AS-Interface addresses 1 - 31
AS-Interface inputs Acc. to ASi Safety at Work
Influenced by door position CTP-..-AS2.. D0, D1, D2, D3
AS-Interface outputs
Guard locking solenoid D0 (1 = solenoid energized)
Reliability values acc. to EN ISO 13849-1
Mission time 20 years
Monitoring of the guard position
Category 4
Performance Level (PL) e
PFH
D
4.1 x 10
-9
/h
1) Dependent on the actuator used.
13.1.1. Typical system times
Refer to the technical data for the exact values.
Ready delay
: After switch-on, the device carries out a self-test. The system is ready for operation only after this time.
Turn-on time of safety outputs
: The max. reaction time t
on
is the time from the moment when the guard is locked to the
moment when the safety outputs switch on.
Risk time according to EN 60947-5-3
: If an actuator moves outside the actuating range, transmission of the code
sequence on the corresponding safety switch is deactivated at the latest after the risk time.