MR-900T User Manual
72
Appendix 8: Send/Receive SMS
with the Router’s Serial Port
MR-900T supports sending/receiving SMSs via user serial port. The method is
described below:
1)
Connect PC (or user device) with the router’s user serial port via standard
RS232 serial cable;
2)
Go to router’s configuration web page, according to Ch. 2.1 Configurations, and
choose “DTU function” ->”Simple Cfg” to set parameters for user serial port,
including baud rate, data bits, parity, stop bits and flow control; by default they
are 9600, 8, No parity, 1, and No flow control. Make sure that the values of
these parameters are set the same both on the user device and on the router.
Click ”Save” after change and reboot the router.
Figure Appendix 8-1: Configure router’s serial port
3)
Use command AT+SMS or AT+SMSA on PC (or user device) to send SMSs. For
example, use tool Serial Interface on PC to send SMS, choose COM1 and set
Содержание MR-900T
