EtungTech
LED-328 User Manual
22
Figure 2-15: Set SMS password
2.
Use AT commands to remotely modify IP address and port within
LED-328.
1)
AT commands need to be sent from mServer. So this way applies only
when customer builds its own mServer, and LED-328 must appear
online in mServer.
2)
Methods: Select the device in mServer, right-click it and select
"Remote Config", at the left part of the dialog, input the following
command in "Command List": AT+MSERVER=IP,PORT
For example,
AT+MSERVER=eyun.etungtech.com,8080
After that click button "Send", if all operations are correct, in the list
of "CMD Response" at the right part, an "OK" will appear. Then
LED-328 will be offline from this mServer, and connect to the new
data center and port.
Figure 2-16: Remote configuration with AT commands
