4930638-02 - Page 2
Assembly Procedures
Lay the bench upside down on the
floor. Locate the two stand legs.
1
Insert 5/16” x 1 1/2” bolts with nylon
washers into both hinge brackets. Tighten
bolts into the endcap threaded inserts
until snug, then an additional half turn.
Do not overtighten to avoid damaging
threaded inserts.
6
The gas springs have a locking
mechanism. Follow the directions
below for the type you received.
7
Lift the canopy and hold it
between the hinge brackets.
5
Place the bushings
into hinge brackets.
4
Turn bench over. Install hinge brackets
to ends of bench such that the short
boss engages the stud above the bolt
hole, and the long boss engages the
hole below the bolt hole. Secure using
5/16” x 1” Allen-head bolts and 5/16”
metal washers. Tighten bolt snug, then
an additional half turn.
3
Remove the six 5/16” x 1” bolts and
5/16” washers installed in the bench.
Attach the stand legs, with the two
small skirt mounting holes toward the
front
, by installing the center bolt first.
You may have to gently push the sides
of the legs in to align holes. Tighten
with the Allen wrench.
2
With a helper holding the canopy open,
align ends of gas spring ball joints with
pivot studs and push into place. Be sure
rod end is down as shown. DO NOT lower
canopy until both gas springs are engaged!
8
Lift and lower canopy a few
times to lubricate gas springs
for optimum performance.
9
Connect the canopy to
bench power cord to the
bench receptacle. Align the
terminals and firmly push
on until seated then tighten
the threaded locking ring.
10
Plug the three-prong 220V AC
power cord into a dedicated outlet
(see
Electrical Requirements
).
11
SKIRT MOUNTING HOLES
ELECTRICAL CONNECTOR
INDICATES BACK OF BENCH
STUD
SHORT BOLT
Type 1
Pry back the
locking clip
with a flat
screwdriver.
Type 2
Remove locking
clip to install or
remove gas spring.
PIVOT STUD
CAUTION
Failure to engage locking clips may
result in the ball joints working loose,
allowing the canopy to fall, which may
result in damage to the unit and injury.
THREADED
LOCKING RING
RECEPTACLE
ON BENCH
CANOPY TO BENCH
POWER CORD
